I can't enable my 1-Wire adapter. What's wrong?

If you're running the 1-Wire server on Linux, the most common issue is the lack of privileges. For most 1-Wire adapters, the server needs root privileges. If this is not the case, the server can't access the 1-Wire adapter when it's enabled.

Example running the server as root:

$ sudo /opt/owsas/bin/owsas -v

If your adapter is a DS9490 or other USB-based device, make sure it's inserted properly into the USB receptacle. A bad contact often leads to a disabled adapter. Also, on Windows, check the USB drivers using the Zadig tool or Device Manager. We recommend to install libusbK for these adapters, altough WinUSB may work properly as well.

I press "Explore" in the Control Panel, open and edit a configuration file, but then I can't save the changes. What's wrong?

This may happen if you installed the software on Windows Vista or later, and checked option "Install for everyone using this computer" during installation. The software was installed in "Program Files" (32-bit Windows) or "Program Files (x64)" (64-bit Windows) which implies only a user with Administrator rights may change files. Please have a look at the folder location in the explorer that pops up after you press the "Explore" button.

If you're logged in as a user with limited access rights, you won't be able to overwrite files located beneath the program files folder. Your editor may say "Access denied" or switch to "save as...".


I want to hook up a DS18B20 to the GPIO header of my RPi and read the temperature. Can I do this with the 1-Wire server?

Yes, you can, starting with v1.1.0 of the software.

First, connect the DS18B20 to the GPIO pins. Don't forget the 4.7K pull-up resistor between Vcc and 1-Wire DATA. We're not going to repeat schematic and explanation here, if you search the Internet for "raspberry ds18b20", plenty of good information will show up.

The 1-Wire server relies on W1 to access the temperature sensor. Driver w1-gpio must be loaded. Again, plenty of good information is available on the Internet.

The 1-Wire server must be told to use W1. You can do this in the GUI (settings page -> W1 Subsystem -> check "Enabled" -> click "SET"). A 1-Wire adapter will show up in the 1-Wire topology page. Next, enumerate the adapter after which the temperature sensor appears. Now you can click "FORCED SENSE" to sample the temperature.

RPi2 GPIO DS18B20 1-Wire Server GUI